Auseal EC25 Jasper (Brown) Sealer 20L for Concrete Sleepers

$159.00 +GST

EC25 is a general purpose concrete sealant designed specifically for sealing and protecting dry concrete sleepers with a medium gloss finish. EC25 is made entirely of acrylic copolymer.

1000 in stock

Add to Cart
Auseal EC25 Jasper (Brown) Sealer 20L for Concrete Sleepers
Auseal EC25 Jasper (Brown) Sealer 20L for Concrete Sleepers
$159.00 +GST

Taper Allowance

Sunset Sleepers Taper Allowance for Concrete Sleepers
Small taper (5-10mm) at the ends from face to back of sleeper

Please note that all of our concrete sleepers have a small taper (5-10mm) at the ends from face to back of sleeper to aid in the demoulding of the sleeper during the production process. For more information, please see our Engineering Guide or reach out to our support team for any questions.

Features

  • Excellent durability – good UV stability
  • Excellent Water Resistance
  • Reduces Efflorescence
  • Suitability for both Interior and Exterior application.
  • Low tyre marking characteristics
  • Suitability for concrete, brick, terracotta and slate
  • Coverage

5 – 7 square metres per litre, depending on surface profile and porosity. The first coat should be diluted up to 20% with solvent.

Surface Cleaning

Dust, dirt, oil, grease, and other contaminants must be removed from all surfaces to be sealed or coated.

Degrease all surfaces and rinse thoroughly with clean water, scrubbing to remove all contaminants while washing down the area. Repeat this procedure until all contaminant residues have been removed.

If the surface is not profiled, acid etch it with hydrochloric acid diluted 10 parts water to 1 part acid. Broom on the surface and leave to react for 10 minutes. Allow to dry before hosing off with copious amounts of fresh water.

Allow the surface to completely dry before applying the sealer.

Application

To ensure uniformity, thoroughly stir before and during application, making sure that any suspended pigment (if coloured) is completely re-incorporated.

To aid penetration and adhesion, the first coat should be thinned with 10-20% Xylene.

Using a broom, roller, or spray gun, apply the coating evenly. Blisters can form if the product is applied unevenly.

Allow the recommended drying time before applying a full second coat without dilution.

Additional information

Liters

20 Litres

Colour

Jasper (Brown)